The Curved Heated Drop-In Hot Food Well is an electric unit that can accommodate (2) 12" x 20" pans. It features individual infinite temperature control for each well and has an 18-gauge stainless steel top. The exterior body is made of galvanized steel and it has a non-marring press fit top gasket. The unit also includes a 1/2" stainless steel drain and can be used for wet and dry operations. It is cUL, UL, and NSF certified and has a power output of 2000 watts. Some of the standard features of this unit include wet and dry operation, a galvanized exterior body, and the need for hard wiring during installation. It also has a non-marring press fit top gasket and a standard 1/2" stainless steel drain. The top is made of 18-gauge stainless steel and the unit comes with a one-year parts and 90-day labor warranty. The wells are slightly depressed into the top to hold in condensation and are flush mounted with die-stamped 12" x 20" individual 20-gauge wells. The hot food wells are manifolded together to one main gate valve. The unit is insulated on all sides with 1" of fiberglass and has 2" of fiberfrax blanket insulation on the bottom. It comes with individual infinite temperature controls that are wired to one main control panel with 4' of conduit and wire. The control panel can be installed at the desired location. There are also various options and accessories available for this unit, including adapter plates and bars, the option to omit drains and manifold, an energy-saving power well (ESP), a 220 volt, 50 cycle electrical system, and Flexishield® food shields for single or dual service. However, including certain options may alter the electrical specifications of the unit. In terms of specifications, the top of the unit is made of one-piece 18-gauge stainless steel with die-stamped openings. Each well is 6.25" deep and has an individual temperature control and 1000 watt heating element attached to the bottom. The wells also have a .5" female N.P.T. drain located in the right rear corner, which all manifold to a .5" gate valve on the left. The exterior housing is made of 20-gauge galvanized steel and the unit is insulated on the sides with 1" fiberglass and on the bottom with
