The Drop-In Hot Food Well Unit is an electric unit with individual pans. It is a wet/dry type with a drain and manifold. It can accommodate 1-pan size for a 12" x 20" pan. The unit features individual infinite temperature controls and a stainless steel top and wells. The outer liner is galvanized and requires a 16-7/8" x 25" cutout. Standard features of the unit include wet and dry operation, a galvanized exterior body, availability for quick shipment, and the requirement of being hard wired in the field. It also has a non-marring press fit top gasket, standard 1/2" stainless steel drain(s), and a one-year parts and 90-day labor standard warranty. The wells are slightly depressed into the top to hold in condensation. The unit has flush mounted die stamped drawn 12" x 20" individual 20-gauge wells. The 11.87" x 19.87" single hot food wells are manifolded together standard to one main gate valve. The unit is insulated on all sides with 1" of fiberglass and has 2" of fiberfrax blanket insulation on the bottom. The individual infinite temperature controls are standard wired to one main control panel with 4' of conduit and wire. The control panel needs to be field installed at the desired location. Options and accessories for the unit include telescoping covers, adapter plates and bars, the option to omit drains and manifold, a 220 volt, 50 cycle electrical system, and single- or double-service flip-up sneeze guards. It is important to note that including certain options may alter the electrical specifications of the unit. The specifications of the unit include a one-piece 18-gauge stainless steel top with a 0.65" overhang around the perimeter. The top has die-stamped 19.87" x 11.87" openings with depressed edges. The formed well below each opening is 6.25" deep. Each well has an individual temperature control and a 1000 watt heating element attached to the bottom of the well. The wells also have a 0.5" female N.P.T. drain located in the right rear corner. All drains are manifolded to a 0.5" gate valve at the left. The exterior housing is made of 20-gauge galvanized steel. The unit is insulated on the sides and between wells
