The refrigerated work table is a three-section unit with a width of 91 inches and a capacity of 24.48 cubic feet. It features two 27-inch doors and one 19-inch door, all made of stainless steel. The top and exterior of the table are also stainless steel, while the interior floor is made of aluminum and the back and sides are made of ABS plastic. The table is equipped with a 4-inch high backsplash and 6-inch casters for easy mobility. The refrigeration system is side-mounted and uses R290 Hydrocarbon refrigerant, which is environmentally friendly. The table is cUL, UL, and NSF certified and comes with a three-year parts and labor warranty, as well as a two-year compressor parts warranty. It is equipped with electronic controls and a stainless steel top. The table can be customized with options such as a lock, legs, tray racks, laminate end, laminate back, refrigerated drawers, laminate facing, additional shelf, cutting board, Celsius readout, and a single tier stainless steel overshelf. The exterior top is made of heavy-duty stainless steel with a 2.12-inch high square nosing at the front. The top is insulated with high-density insulation, while the back and bottom are made of galvanized steel. The ends are finished with stainless steel. The interior base has a stainless steel back and bottom, while the ends and door frames are made of thermoformed ABS plastic. The base is insulated with high-density foamed-in-place polyurethane. Each interior door section has a removable epoxy-coated wire shelf. The doors have a stainless steel exterior front and a thermoformed ABS plastic interior liner. The base has a machine compartment on the right side, which houses the condensing unit, condensate evaporator, and electrical junction box. The machine compartment has a removable louver for access to the condensing unit. The blower coils with expansion valves are located behind the door mullions for even air and temperature control. The refrigeration system uses R290 refrigerant and maintains a temperature of 36°F to 40°F. The electronic temperature controls and pre-wired condensing unit with hot gas condensate evaporator are installed in the machine compartment. The base has on/off switches located behind the louvered panel.
